Clik here to view.
RS232 Driver for 3X Stepper Motor Using Stamp II
Simple hardware and software techniques are illustrated in this project wherein 3 common 4-coil stepper motors are driven and controlled using a single Stamp II board.
View ArticleClik here to view.
Soft Touch Designed ON/OFF Toggle Switch
A soft touch switch is illustrated in this project which can set the device ON by pushing once and set the device OFF by pushing again.
View ArticleClik here to view.
R/C Controlled Shutter Switch for Aiptek Digital Camera
The device was built around a PIC microcontroller was termed as Aip-Axe that allows programming switch-on points and switch/stick direction.
View ArticleClik here to view.
Redefined Features of Smart TV Remote
An ultrasonic sensor is used instead of push buttons in this project where it measures distance from TV as it sends different signals.
View ArticleClik here to view.
Controller Circuit for Church Bells
The main circuit of the church bell controller has a system that is built around an ATmega32 microcontroller and a 24LC32 EEPROM.
View ArticleClik here to view.
Parallel Port Used to Control Stepper Motor
Featured in this project is the control of a stepper motor with its speed, direction, and step size by sending some signals through the parallel port.
View ArticleClik here to view.
Soldering Hotplate Controlled by PID
The project aims to control the temperature of a soldering hotplate by using a proportional integral controller (PID) while refrigerating the solder paste to maintain its shelf life.
View ArticleClik here to view.
Developing the Open Automation Project
The possibility of assembling an intelligent PC-based mobile robot suitable for home or office environments is featured in this project by engineering modular software and electronic components.
View ArticleClik here to view.
The Truth About NICEBOTS
The project showcases the construction and design of interactive robots in a one-month long open studio exhibit known as NICEBOTS.
View ArticleClik here to view.
IR Remote Control for Hero Robot
This IR remote control interface project is designed for the Hero Robot as it incorporates the use of PIC16F688 microcontroller along with the BASIC Stamp II.
View Article
